How to soundproof and reduce noise in diesel generators

Jun 12, 2025

Leave a message

(1) The computer room is soundproof. After the exhaust noise and cooling fan noise of the unit have decreased, the remaining primary noise sources are diesel engine mechanical noise and incineration noise. The selected method is to remove all windows except for the necessary internal wall observation windows connected to the observation room. All holes and openings should be tightly sealed, and the sound insulation of brick walls should be above 40dB. Fire resistant and soundproof doors and windows are selected for the computer room.
(2) Air intake and exhaust. After the sound insulation treatment of the computer room, the ventilation and heat dissipation issues inside the room need to be addressed. The air inlet should be set on the same straight line as the generator set and exhaust outlet. The air inlet should be equipped with a resistive plate muffler, as the pressure loss at the air inlet is also within the allowable range, which can naturally balance the air flow in and out of the computer room, and have a significant ventilation and heat dissipation effect.
(3) Sound absorption treatment. The five walls in the computer room, except for those above ground, can be treated with sound absorption. Perforated plate resonant sound absorption structures are selected based on the frequency spectrum characteristics of the generator set.
(4) The communication of indoor air and the excellent sound insulation of the computer room can prevent the air in the room from convection when the closed water-cooled generator unit is shut down, and the high temperature in the room cannot be reduced in time. Low noise axial flow fans can be used, coupled with resistive plate mufflers, to solve the problem.
(5) Unit isolation. Before installing the generator set, strict vibration isolation treatment should be carried out according to the relevant materials provided by the manufacturer to prevent the formation of long-distance transmission of structural sound, and continuous emission of air noise during transmission cannot meet the qualified noise level at the factory boundary. For existing generator sets that require management due to overspending, it is necessary to measure the oscillation conditions on the ground near the units. If the vibration is significant, the generator sets should be isolated first.

 

Send Inquiry