1. When the engine is running, the coolant vapor enters and expands into the tank. After cooling, it passes through the radiator, which can prevent a large amount of evaporation loss of the coolant and increase the temperature of the coolant boiling point. The dental cooling system uses high-quality coolant with anti-corrosion, boiling, anti freezing, and anti scaling properties, and requires sealing during use to achieve satisfactory results.
2. Keeping the exterior and interior of the cooling system clean is one of the important conditions for improving cooling performance. The exterior of the radiator is attached with mud, oil, and radiator. If it deforms due to collision, it will affect the passage of wind, deteriorate the heat effect of the radiator, and cause the coolant temperature to be too high. Therefore, if this situation is found in the generator radiator, it must be cleaned or repaired immediately. In addition, the accumulation of mud and oil in the cooling box of the generator set can affect the heat transfer of the coolant. The supplementation of low-quality coolant and water will increase the scale in the cooling system, but the heat transfer capacity of scale is only a few tens of times that of metal, and the cooling effect deteriorates. Therefore, please add high-quality coolant to the cooling system.
3. When the coolant Yang Yi maintains sufficient engine cooling, the coolant level should be between the highest and lowest marks of the expansion tank. If the level is lower than the lowest mark of the expansion tank, it should be added immediately. The coolant in the expansion tank is insufficient. There will still be expansion.
4. Properly maintain the tension of the fan belt. If the fan is loose and the pump speed is too low, it will affect the circulation of coolant and accelerate belt wear. However, if the tape is too tight, the pump bearings will wear out. In addition, if there are oil stains on the tape, it can also cause problems. Therefore, please regularly check the tension of the fan tape adjustment.
5. Avoid excessive load on diesel generator sets, prolonged use, high engine load, and high coolant temperature.
6. The computer room has good ventilation. Especially the smoke discharged from the water tank is very good, the ground is very clean, and be careful not to produce oil, dust, etc.
