Check the fuel filter element. If it is clogged or contains a large amount of impurities, please replace the fuel filter; Check the fuel supply pipeline, if there is any leakage, take measures to prevent air from entering the fuel supply pipeline during engine operation; Check the air filter element and clean or replace it with compressed air; Measure the fuel temperature. If the fuel temperature exceeds 50 ℃, please cool down or replenish the fuel to reduce its temperature; Check the engine exhaust pipe to ensure that it is unobstructed and that the exhaust pressure is less than 90mmHg; After being in a cold state or stopped for 5-10 minutes, check the oil level in the oil pan with the dipstick. If the oil level has exceeded the "H" position, drain the excess oil and keep the level between the "L" and "H" positions close to the "H" position; During operation, use necessary tools to inspect the air pipe between the rear end of the turbocharger and the intake manifold (taking care to prevent burns caused by high temperature and high pressure gases), and tighten the areas with air leaks.
The working temperature of diesel generator sets is one of the important factors affecting wear and tear. During use, due to the limitations of the cooling system structure, changes in workload and speed, changes in ambient temperature, and other factors, the operating temperature of the diesel generator set varies greatly. Practice has shown that it is advantageous to control the cooling water temperature between 75-85 ℃ and the lubricating oil temperature between 75-95 ℃.
At present, most of the large high-voltage motors in China use separated sliding bearings, which generally have fewer bearing failures and have little impact on the motor due to oil leakage from the bearing shells. However, the structures of some large high-voltage motors and medium-sized motors are "end cover sliding bearings" and "end cover rolling bearings", and there are many problems with the bearings of these motors:
When the temperature is high, the engine is prone to overheating, the viscosity of lubricating oil is low, and the wear of parts increases. When the temperature is low, the viscosity of lubricating oil increases, making it difficult to start the diesel generator. During operation, the cooling water cannot maintain a normal temperature, which increases the wear and corrosion of parts. When the diesel generator set starts at low temperatures, the wear is more severe.

