Method For Adjusting The Fuel Supply Of Diesel Generator Sets

Jun 22, 2025

Leave a message

People who use diesel generator sets know that we cannot avoid various problems, such as uneven fuel supply in each cylinder, sometimes the fuel supply in the cylinder is too large, and sometimes the fuel supply in the cylinder is too small. This situation will directly affect the stability of the engine operation. The fuel injection pump can be removed and checked and adjusted on the test bench; However, if there is no test bench and uneven fuel supply inspection is necessary, a rough inspection of the suspected cylinder's fuel supply can also be conducted. Below are the methods for checking and adjusting the fuel supply of diesel generator sets:
1. Prepare two glass measuring cylinders for later use. If you cannot find the measuring cylinder at the moment, you can also use two identical small bottles as substitutes.
2. Remove the high-pressure oil pipe joint connecting the cylinder with excessive (or insufficient) fuel supply to the injector.
3. Remove the high-pressure pipe joint connecting the cylinder with normal fuel supply and the fuel injector.
4. Insert the ends of two oil tubes into two measuring cylinders (or small bottles) respectively.
5. Use a starter motor to drive the engine and rotate the fuel injection pump to pump oil.
6. The generator manufacturer reminds you that when there is a certain amount of diesel in the equivalent cylinder (or small bottle), place the cylinder on a level and compare the amount of fuel to determine whether the fuel supply is too large or too small. If a small bottle is used instead, it can be weighed and compared; The relative position of the fork (or ring gear) on the fuel injection pump adjustment rod (i.e. gear rod) can be changed for adjustment. The P-type pump can be adjusted by rotating the flange sleeve.

 

Send Inquiry