How to deal with deformation of diesel generator parts

Jun 17, 2025

Leave a message

The deformation of the components of the diesel generator set itself. Because during the use of diesel generator sets, some components may deform due to the force acting on them. Especially for some basic parts such as cylinder block and cylinder head, deformation can seriously shorten the service life of diesel generator sets, so you can replace these basic parts in advance.

 

Diesel generator set is a type of AC power supply equipment for self owned power stations. It is a small independent power generation device that uses internal combustion engines as power to drive synchronous AC generators and generate electricity. By installing the brushless synchronous AC generator coaxially with the crankshaft of the diesel engine, the rotation of the diesel generator set can be used to drive the rotor of the generator. Using the principle of 'electromagnetic induction', the generator will output induced electromotive force, which can generate current through a closed load circuit.

 

The clean air filtered by the air filter inside the cylinder of the diesel generator set is fully mixed with the high-pressure atomized diesel injected from the fuel injector. Under the upward pressure of the piston of the diesel generator set, the volume shrinks and the temperature rapidly rises, reaching the ignition point of diesel. Diesel is ignited, and the mixed gas burns violently, rapidly expanding in volume and pushing the piston downwards, which is called 'work'. The cylinders of the diesel generator set work in a certain order, and the thrust on the piston is converted into a force that drives the crankshaft to rotate through the connecting rod, thereby driving the crankshaft to rotate. In this way, the diesel generator completes a working cycle.

As one working cycle after another is repeated, the diesel generator set runs continuously. The control core of a diesel engine is to regulate and stabilize the speed by controlling the fuel injection pump, which is generally divided into mechanical speed regulation and electronic speed regulation. The electronic governor adopts dual closed-loop control, using a speed sensor to detect the speed of the diesel engine, converting the detection result into a proportional electrical signal, comparing it with the given standard speed signal to obtain a deviation signal, and then adding it to the position feedback signal of the diesel generator set actuator. The synthesized signal is used as the input signal for the actuator action, and the fuel supply is adjusted by controlling the position of the fuel injection pump rod of the diesel generator set to achieve the purpose of speed regulation and stability. At present, foreign diesel engines also adopt advanced engine "electronic injection" control technology, which has excellent performance in load characteristics, fuel saving and environmental emissions reduction, and noise reduction. The active power regulation of the generator set is the regulation of the speed of the diesel generator.

 

Send Inquiry